Audi A6 C6 Mk2 2008 to 2010 2.8 FSi remap
Standard this engine makes 220hp and 280Nm. Our STAGE 1 file takes it to 248hp and 305Nm.
Where the power arrives
Power and torque through the rev range, on the STAGE 1 file.
- Standard 220hp
- Remapped 248hp
- Standard 280Nm
- Remapped 305Nm
Stages for this engine
Stage 1 needs nothing fitted. Anything above assumes the supporting hardware is on the car already.
Remapping the 2.8 FSi
The Audi A6 C6 Mk2 2008 to 2010 2.8 FSi runs a factory calibration built to cope with poor fuel, skipped servicing and hot countries. We rewrite the fuelling, boost and timing for this engine on this car, then test it before you get it back. The original file is kept, so it can go back to standard whenever you want.
On the petrol side the difference shows in throttle response and in how hard it pulls through the top half of the rev range. It feels sharper off idle and keeps going where it used to flatten out.
Figures on this page are for a standard car in good health. We read the fault codes and check the basics first, and if something needs attention we will tell you before we write anything. Have a look at the other engines on the C6 Mk2 2008 to 2010, the full A6 range, or everything we do for Audi.
Other engines on this A6
C6 Mk2 2008 to 2010 cars.
- 2.0 TDi136hp standardDiesel
- 2.0 TDi140hp standardDiesel
- 2.0 TDi163hp standardDiesel
- 2.7 TDi163hp standardDiesel
- 2.0 TDi170hp standardDiesel
- 2.7 TDi190hp standardDiesel
- 3.0 TDi211hp standardDiesel
- 3.0 TDi240hp standardDiesel
- 2.0 TFSi170hp standardPetrol
- 2.8 FSi190hp standardPetrol
- 3.0 TFSi290hp standardPetrol
- 4.2 FSi350hp standardPetrol
- 5.2 FSi435hp standardPetrol
- RS6 5.0 TFSi580hp standardPetrol
Similar power, other makes
Cars running about the same standard output, for comparison.
Other A6 generations
Book your A6
We write and test every file at our Aston workshop, on our own rolling road. Ring us with your reg and we will tell you what your car should make before you commit to anything.