Audi A6 C6 Mk2 2008 to 2010 3.0 TDi remap
Standard this engine makes 240hp and 500Nm. Our STAGE 2 file takes it to 305hp and 600Nm.
Where the power arrives
Power and torque through the rev range, on the STAGE 2 file.
- Standard 240hp
- Remapped 305hp
- Standard 500Nm
- Remapped 600Nm
Stages for this engine
Stage 1 needs nothing fitted. Anything above assumes the supporting hardware is on the car already.
Remapping the 3.0 TDi
The Audi A6 C6 Mk2 2008 to 2010 3.0 TDi runs a factory calibration built to cope with poor fuel, skipped servicing and hot countries. We rewrite the fuelling, boost and timing for this engine on this car, then test it before you get it back. The original file is kept, so it can go back to standard whenever you want.
Diesels like this one gain most through the middle of the rev range, which is where you actually drive. It pulls from lower down, holds a gear on a hill, and needs fewer downshifts to overtake. Drive it the same way afterwards and the economy usually improves a little.
Figures on this page are for a standard car in good health. We read the fault codes and check the basics first, and if something needs attention we will tell you before we write anything. Have a look at the other engines on the C6 Mk2 2008 to 2010, the full A6 range, or everything we do for Audi.
Other engines on this A6
C6 Mk2 2008 to 2010 cars.
- 2.0 TDi136hp standardDiesel
- 2.0 TDi140hp standardDiesel
- 2.0 TDi163hp standardDiesel
- 2.7 TDi163hp standardDiesel
- 2.0 TDi170hp standardDiesel
- 2.7 TDi190hp standardDiesel
- 3.0 TDi211hp standardDiesel
- 2.0 TFSi170hp standardPetrol
- 2.8 FSi190hp standardPetrol
- 2.8 FSi220hp standardPetrol
- 3.0 TFSi290hp standardPetrol
- 4.2 FSi350hp standardPetrol
- 5.2 FSi435hp standardPetrol
- RS6 5.0 TFSi580hp standardPetrol
Similar power, other makes
Cars running about the same standard output, for comparison.
Other A6 generations
Book your A6
We write and test every file at our Aston workshop, on our own rolling road. Ring us with your reg and we will tell you what your car should make before you commit to anything.