Engine

Claas Axion All years 920 8.7L 320hp (235kW) 1350Nm remap

Standard this engine makes 320hp and 1350Nm. Our Stage 1 file takes it to 392hp and 1680Nm.

+72horsepower
+330newton metres
1stage available

Where the power arrives

Both curves scaled from the manufacturer figures, on the Stage 1 file.

Power before and after
010621231842301,2001,6002,0002,400 RPM 010621231842301,4002,0002,600hp RPM
  • Standard 320hp
  • Remapped 392hp
Torque before and after
04549071361181401,2001,6002,0002,400 RPM 04549071361181401,4002,0002,600Nm RPM
  • Standard 1350Nm
  • Remapped 1680Nm

Stages for this engine

Stage 1 needs nothing fitted. Anything above assumes the supporting hardware is on the car already.

Every figure for the 920 8.7L 320hp (235kW) 1350Nm

FilePowerGainTorqueGainPrice
Standard320hpn/a1350Nmn/an/a
Stage 1392hpup 721680Nmup 330ask us

Economy files show no new power figure because they are written for torque and drivability rather than peak output.

Remapping the 920 8.7L 320hp (235kW) 1350Nm

The Claas Axion All years 920 8.7L 320hp (235kW) 1350Nm runs a factory calibration built to cope with poor fuel, skipped servicing and hot countries. We rewrite the fuelling, boost and timing for this engine on this car, then test it before you get it back. The original file is kept, so it can go back to standard whenever you want.

On the petrol side the difference shows in throttle response and in how hard it pulls through the top half of the rev range. It feels sharper off idle and keeps going where it used to flatten out.

Figures on this page are for a standard car in good health. We read the fault codes and check the basics first, and if something needs attention we will tell you before we write anything. Have a look at the other engines on the All years, the full Axion range, or everything we do for Claas.

Book your Axion

We write and test every file at our Aston workshop, on our own rolling road. Ring us with your reg and we will tell you what your car should make before you commit to anything.