Engine

Claas Axion All years 940 8.7L 383hp (282kW) 1550Nm remap

Standard this engine makes 383hp and 1550Nm. Our Stage 1 file takes it to 473hp and 1930Nm.

+90horsepower
+380newton metres
1stage available

Where the power arrives

Both curves scaled from the manufacturer figures, on the Stage 1 file.

Power before and after
012825538351101,2001,6002,0002,400 RPM 012825538351101,4002,0002,600hp RPM
  • Standard 383hp
  • Remapped 473hp
Torque before and after
052110421563208401,2001,6002,0002,400 RPM 052110421563208401,4002,0002,600Nm RPM
  • Standard 1550Nm
  • Remapped 1930Nm

Stages for this engine

Stage 1 needs nothing fitted. Anything above assumes the supporting hardware is on the car already.

Every figure for the 940 8.7L 383hp (282kW) 1550Nm

FilePowerGainTorqueGainPrice
Standard383hpn/a1550Nmn/an/a
Stage 1473hpup 901930Nmup 380ask us

Economy files show no new power figure because they are written for torque and drivability rather than peak output.

Remapping the 940 8.7L 383hp (282kW) 1550Nm

The Claas Axion All years 940 8.7L 383hp (282kW) 1550Nm runs a factory calibration built to cope with poor fuel, skipped servicing and hot countries. We rewrite the fuelling, boost and timing for this engine on this car, then test it before you get it back. The original file is kept, so it can go back to standard whenever you want.

On the petrol side the difference shows in throttle response and in how hard it pulls through the top half of the rev range. It feels sharper off idle and keeps going where it used to flatten out.

Figures on this page are for a standard car in good health. We read the fault codes and check the basics first, and if something needs attention we will tell you before we write anything. Have a look at the other engines on the All years, the full Axion range, or everything we do for Claas.

Book your Axion

We write and test every file at our Aston workshop, on our own rolling road. Ring us with your reg and we will tell you what your car should make before you commit to anything.