DS DS4 2010 to 2015 1.2 Puretech remap
Standard this engine makes 130hp and 230Nm. Our STAGE 1 file takes it to 145hp and 270Nm.
Where the power arrives
Power and torque through the rev range, on the STAGE 1 file.
- Standard 130hp
- Remapped 145hp
- Standard 230Nm
- Remapped 270Nm
Stages for this engine
Stage 1 needs nothing fitted. Anything above assumes the supporting hardware is on the car already.
Remapping the 1.2 Puretech
The DS DS4 2010 to 2015 1.2 Puretech runs a factory calibration built to cope with poor fuel, skipped servicing and hot countries. We rewrite the fuelling, boost and timing for this engine on this car, then test it before you get it back. The original file is kept, so it can go back to standard whenever you want.
On the petrol side the difference shows in throttle response and in how hard it pulls through the top half of the rev range. It feels sharper off idle and keeps going where it used to flatten out.
Figures on this page are for a standard car in good health. We read the fault codes and check the basics first, and if something needs attention we will tell you before we write anything. Have a look at the other engines on the 2010 to 2015, the full DS4 range, or everything we do for DS.
Other engines on this DS4
2010 to 2015 cars.
- 1.6 e-HDI92hp standardDiesel
- 1.6 HDi112hp standardDiesel
- 1.6 e-HDI115hp standardDiesel
- 1.6 BlueHDi120hp standardDiesel
- 2.0 HDi136hp standardDiesel
- 2.0 BlueHDi150hp standardDiesel
- 2.0 HDi160hp standardDiesel
- 2.0 BlueHDi180hp standardDiesel
- 1.6 VTi120hp standardPetrol
- 1.6 THP155hp standardPetrol
- 1.6 THP160hp standardPetrol
- 1.6 THP165hp standardPetrol
- 1.6 THP200hp standardPetrol
Similar power, other makes
Cars running about the same standard output, for comparison.
Other DS4 generations
Book your DS4
We write and test every file at our Aston workshop, on our own rolling road. Ring us with your reg and we will tell you what your car should make before you commit to anything.