Jaguar XF up to 2015 3.0d remap
Standard this engine makes 240hp and 500Nm. Our STAGE 1 file takes it to 290hp and 575Nm.
Where the power arrives
Power and torque through the rev range, on the STAGE 1 file.
- Standard 240hp
- Remapped 290hp
- Standard 500Nm
- Remapped 575Nm
Stages for this engine
Stage 1 needs nothing fitted. Anything above assumes the supporting hardware is on the car already.
Remapping the 3.0d
The Jaguar XF up to 2015 3.0d runs a factory calibration built to cope with poor fuel, skipped servicing and hot countries. We rewrite the fuelling, boost and timing for this engine on this car, then test it before you get it back. The original file is kept, so it can go back to standard whenever you want.
Diesels like this one gain most through the middle of the rev range, which is where you actually drive. It pulls from lower down, holds a gear on a hill, and needs fewer downshifts to overtake. Drive it the same way afterwards and the economy usually improves a little.
Figures on this page are for a standard car in good health. We read the fault codes and check the basics first, and if something needs attention we will tell you before we write anything. Have a look at the other engines on the up to 2015, the full XF range, or everything we do for Jaguar.
Other engines on this XF
up to 2015 cars.
Similar power, other makes
Cars running about the same standard output, for comparison.
Other XF generations
Book your XF
We write and test every file at our Aston workshop, on our own rolling road. Ring us with your reg and we will tell you what your car should make before you commit to anything.