Engine

John Deere 6R Series All years 6140R 140hp (103kW) 656Nm remap

Standard this engine makes 140hp and 656Nm. Our Stage 1 file takes it to 170hp and 794Nm.

+30horsepower
+138newton metres
1stage available

Where the power arrives

Both curves scaled from the manufacturer figures, on the Stage 1 file.

Power before and after
0469213818401,2001,6002,0002,400 RPM 0469213818401,4002,0002,600hp RPM
  • Standard 140hp
  • Remapped 170hp
Torque before and after
021442964385801,2001,6002,0002,400 RPM 021442964385801,4002,0002,600Nm RPM
  • Standard 656Nm
  • Remapped 794Nm

Stages for this engine

Stage 1 needs nothing fitted. Anything above assumes the supporting hardware is on the car already.

Every figure for the 6140R 140hp (103kW) 656Nm

FilePowerGainTorqueGainPrice
Standard140hpn/a656Nmn/an/a
Stage 1170hpup 30794Nmup 138ask us

Economy files show no new power figure because they are written for torque and drivability rather than peak output.

Remapping the 6140R 140hp (103kW) 656Nm

The John Deere 6R Series All years 6140R 140hp (103kW) 656Nm runs a factory calibration built to cope with poor fuel, skipped servicing and hot countries. We rewrite the fuelling, boost and timing for this engine on this car, then test it before you get it back. The original file is kept, so it can go back to standard whenever you want.

On the petrol side the difference shows in throttle response and in how hard it pulls through the top half of the rev range. It feels sharper off idle and keeps going where it used to flatten out.

Figures on this page are for a standard car in good health. We read the fault codes and check the basics first, and if something needs attention we will tell you before we write anything. Have a look at the other engines on the All years, the full 6R Series range, or everything we do for John Deere.

Book your 6R Series

We write and test every file at our Aston workshop, on our own rolling road. Ring us with your reg and we will tell you what your car should make before you commit to anything.