Engine

John Deere 6R Series All years 6190R 190hp (140kW) 890Nm remap

Standard this engine makes 190hp and 890Nm. Our Stage 1 file takes it to 215hp and 1032Nm.

+25horsepower
+142newton metres
1stage available

Where the power arrives

Both curves scaled from the manufacturer figures, on the Stage 1 file.

Power before and after
05811617423201,2001,6002,0002,400 RPM 05811617423201,4002,0002,600hp RPM
  • Standard 190hp
  • Remapped 215hp
Torque before and after
0279557836111501,2001,6002,0002,400 RPM 0279557836111501,4002,0002,600Nm RPM
  • Standard 890Nm
  • Remapped 1032Nm

Stages for this engine

Stage 1 needs nothing fitted. Anything above assumes the supporting hardware is on the car already.

Every figure for the 6190R 190hp (140kW) 890Nm

FilePowerGainTorqueGainPrice
Standard190hpn/a890Nmn/an/a
Stage 1215hpup 251032Nmup 142ask us

Economy files show no new power figure because they are written for torque and drivability rather than peak output.

Remapping the 6190R 190hp (140kW) 890Nm

The John Deere 6R Series All years 6190R 190hp (140kW) 890Nm runs a factory calibration built to cope with poor fuel, skipped servicing and hot countries. We rewrite the fuelling, boost and timing for this engine on this car, then test it before you get it back. The original file is kept, so it can go back to standard whenever you want.

On the petrol side the difference shows in throttle response and in how hard it pulls through the top half of the rev range. It feels sharper off idle and keeps going where it used to flatten out.

Figures on this page are for a standard car in good health. We read the fault codes and check the basics first, and if something needs attention we will tell you before we write anything. Have a look at the other engines on the All years, the full 6R Series range, or everything we do for John Deere.

Book your 6R Series

We write and test every file at our Aston workshop, on our own rolling road. Ring us with your reg and we will tell you what your car should make before you commit to anything.