Engine

John Deere 6R Series All years 6210R 210hp (154kW) 890Nm remap

Standard this engine makes 210hp and 983Nm. Our Stage 1 file takes it to 240hp and 1112Nm.

+30horsepower
+129newton metres
1stage available

Where the power arrives

Both curves scaled from the manufacturer figures, on the Stage 1 file.

Power before and after
06513019425901,2001,6002,0002,400 RPM 06513019425901,4002,0002,600hp RPM
  • Standard 210hp
  • Remapped 240hp
Torque before and after
0300600901120101,2001,6002,0002,400 RPM 0300600901120101,4002,0002,600Nm RPM
  • Standard 983Nm
  • Remapped 1112Nm

Stages for this engine

Stage 1 needs nothing fitted. Anything above assumes the supporting hardware is on the car already.

Every figure for the 6210R 210hp (154kW) 890Nm

FilePowerGainTorqueGainPrice
Standard210hpn/a983Nmn/an/a
Stage 1240hpup 301112Nmup 129ask us

Economy files show no new power figure because they are written for torque and drivability rather than peak output.

Remapping the 6210R 210hp (154kW) 890Nm

The John Deere 6R Series All years 6210R 210hp (154kW) 890Nm runs a factory calibration built to cope with poor fuel, skipped servicing and hot countries. We rewrite the fuelling, boost and timing for this engine on this car, then test it before you get it back. The original file is kept, so it can go back to standard whenever you want.

On the petrol side the difference shows in throttle response and in how hard it pulls through the top half of the rev range. It feels sharper off idle and keeps going where it used to flatten out.

Figures on this page are for a standard car in good health. We read the fault codes and check the basics first, and if something needs attention we will tell you before we write anything. Have a look at the other engines on the All years, the full 6R Series range, or everything we do for John Deere.

Book your 6R Series

We write and test every file at our Aston workshop, on our own rolling road. Ring us with your reg and we will tell you what your car should make before you commit to anything.