Landrover Evoque 2019 onwards D240 remap
Standard this engine makes 240hp and 500Nm. Our STAGE 1 file takes it to 260hp and 550Nm.
Where the power arrives
Power and torque through the rev range, on the STAGE 1 file.
- Standard 240hp
- Remapped 260hp
- Standard 500Nm
- Remapped 550Nm
Stages for this engine
Stage 1 needs nothing fitted. Anything above assumes the supporting hardware is on the car already.
Remapping the D240
The Landrover Evoque 2019 onwards D240 runs a factory calibration built to cope with poor fuel, skipped servicing and hot countries. We rewrite the fuelling, boost and timing for this engine on this car, then test it before you get it back. The original file is kept, so it can go back to standard whenever you want.
Diesels like this one gain most through the middle of the rev range, which is where you actually drive. It pulls from lower down, holds a gear on a hill, and needs fewer downshifts to overtake. Drive it the same way afterwards and the economy usually improves a little.
Figures on this page are for a standard car in good health. We read the fault codes and check the basics first, and if something needs attention we will tell you before we write anything. Have a look at the other engines on the 2019 onwards, the full Evoque range, or everything we do for Landrover.
Other engines on this Evoque
2019 onwards cars.
Similar power, other makes
Cars running about the same standard output, for comparison.
Other Evoque generations
Book your Evoque
We write and test every file at our Aston workshop, on our own rolling road. Ring us with your reg and we will tell you what your car should make before you commit to anything.