Porsche Panamera 970 2013 onwards 4.8i S/4S remap
Standard this engine makes 420hp and 520Nm. Our STAGE 1 file takes it to 440hp and 540Nm.
Where the power arrives
Power and torque through the rev range, on the STAGE 1 file.
- Standard 420hp
- Remapped 440hp
- Standard 520Nm
- Remapped 540Nm
Stages for this engine
Stage 1 needs nothing fitted. Anything above assumes the supporting hardware is on the car already.
Remapping the 4.8i S/4S
The Porsche Panamera 970 2013 onwards 4.8i S/4S runs a factory calibration built to cope with poor fuel, skipped servicing and hot countries. We rewrite the fuelling, boost and timing for this engine on this car, then test it before you get it back. The original file is kept, so it can go back to standard whenever you want.
On the petrol side the difference shows in throttle response and in how hard it pulls through the top half of the rev range. It feels sharper off idle and keeps going where it used to flatten out.
Figures on this page are for a standard car in good health. We read the fault codes and check the basics first, and if something needs attention we will tell you before we write anything. Have a look at the other engines on the 970 2013 onwards, the full Panamera range, or everything we do for Porsche.
Similar power, other makes
Cars running about the same standard output, for comparison.
Other Panamera generations
Book your Panamera
We write and test every file at our Aston workshop, on our own rolling road. Ring us with your reg and we will tell you what your car should make before you commit to anything.