Engine

Steyr 6000serie All years 6225 CVT 225hp (165kW) 850Nm remap

Standard this engine makes 225hp and 850Nm. Our Stage 1 file takes it to 262hp and 995Nm.

+37horsepower
+145newton metres
1stage available

Where the power arrives

Both curves scaled from the manufacturer figures, on the Stage 1 file.

Power before and after
07114121228301,2001,6002,0002,400 RPM 07114121228301,4002,0002,600hp RPM
  • Standard 225hp
  • Remapped 262hp
Torque before and after
0269537806107501,2001,6002,0002,400 RPM 0269537806107501,4002,0002,600Nm RPM
  • Standard 850Nm
  • Remapped 995Nm

Stages for this engine

Stage 1 needs nothing fitted. Anything above assumes the supporting hardware is on the car already.

Every figure for the 6225 CVT 225hp (165kW) 850Nm

FilePowerGainTorqueGainPrice
Standard225hpn/a850Nmn/an/a
Stage 1262hpup 37995Nmup 145ask us

Economy files show no new power figure because they are written for torque and drivability rather than peak output.

Remapping the 6225 CVT 225hp (165kW) 850Nm

The Steyr 6000serie All years 6225 CVT 225hp (165kW) 850Nm runs a factory calibration built to cope with poor fuel, skipped servicing and hot countries. We rewrite the fuelling, boost and timing for this engine on this car, then test it before you get it back. The original file is kept, so it can go back to standard whenever you want.

On the petrol side the difference shows in throttle response and in how hard it pulls through the top half of the rev range. It feels sharper off idle and keeps going where it used to flatten out.

Figures on this page are for a standard car in good health. We read the fault codes and check the basics first, and if something needs attention we will tell you before we write anything. Have a look at the other engines on the All years, the full 6000serie range, or everything we do for Steyr.

Book your 6000serie

We write and test every file at our Aston workshop, on our own rolling road. Ring us with your reg and we will tell you what your car should make before you commit to anything.