Engine

Steyr Profi All years 4120 4.5L 121hp (89kW) 549Nm remap

Standard this engine makes 121hp and 549Nm. Our Stage 1 file takes it to 146hp and 638Nm.

+25horsepower
+89newton metres
1stage available

Where the power arrives

Both curves scaled from the manufacturer figures, on the Stage 1 file.

Power before and after
0397911815801,2001,6002,0002,400 RPM 0397911815801,4002,0002,600hp RPM
  • Standard 121hp
  • Remapped 146hp
Torque before and after
017234551768901,2001,6002,0002,400 RPM 017234551768901,4002,0002,600Nm RPM
  • Standard 549Nm
  • Remapped 638Nm

Stages for this engine

Stage 1 needs nothing fitted. Anything above assumes the supporting hardware is on the car already.

Every figure for the 4120 4.5L 121hp (89kW) 549Nm

FilePowerGainTorqueGainPrice
Standard121hpn/a549Nmn/an/a
Stage 1146hpup 25638Nmup 89ask us

Economy files show no new power figure because they are written for torque and drivability rather than peak output.

Remapping the 4120 4.5L 121hp (89kW) 549Nm

The Steyr Profi All years 4120 4.5L 121hp (89kW) 549Nm runs a factory calibration built to cope with poor fuel, skipped servicing and hot countries. We rewrite the fuelling, boost and timing for this engine on this car, then test it before you get it back. The original file is kept, so it can go back to standard whenever you want.

On the petrol side the difference shows in throttle response and in how hard it pulls through the top half of the rev range. It feels sharper off idle and keeps going where it used to flatten out.

Figures on this page are for a standard car in good health. We read the fault codes and check the basics first, and if something needs attention we will tell you before we write anything. Have a look at the other engines on the All years, the full Profi range, or everything we do for Steyr.

Book your Profi

We write and test every file at our Aston workshop, on our own rolling road. Ring us with your reg and we will tell you what your car should make before you commit to anything.