Engine

Steyr Profi All years CVT 4110 4.5L 110hp (81kW) 498Nm remap

Standard this engine makes 110hp and 498Nm. Our Stage 1 file takes it to 142hp and 625Nm.

+32horsepower

+127newton metres

1stage available

Where the power arrives

Both curves scaled from the manufacturer figures, on the Stage 1 file.

Power before and after

Standard 110hp
Remapped 142hp

Torque before and after

Standard 498Nm
Remapped 625Nm

Stages for this engine

Stage 1 needs nothing fitted. Anything above assumes the supporting hardware is on the car already.

Stage 1142hpup 32625Nmup 127

Every figure for the CVT 4110 4.5L 110hp (81kW) 498Nm

File	Power	Gain	Torque	Gain	Price
Standard	110hp	n/a	498Nm	n/a	n/a
Stage 1	142hp	up 32	625Nm	up 127	ask us

Economy files show no new power figure because they are written for torque and drivability rather than peak output.

Remapping the CVT 4110 4.5L 110hp (81kW) 498Nm

The Steyr Profi All years CVT 4110 4.5L 110hp (81kW) 498Nm runs a factory calibration built to cope with poor fuel, skipped servicing and hot countries. We rewrite the fuelling, boost and timing for this engine on this car, then test it before you get it back. The original file is kept, so it can go back to standard whenever you want.

On the petrol side the difference shows in throttle response and in how hard it pulls through the top half of the rev range. It feels sharper off idle and keeps going where it used to flatten out.

Figures on this page are for a standard car in good health. We read the fault codes and check the basics first, and if something needs attention we will tell you before we write anything. Have a look at the other engines on the All years, the full Profi range, or everything we do for Steyr.

Other engines on this Profi

All years cars.

Book your Profi

We write and test every file at our Aston workshop, on our own rolling road. Ring us with your reg and we will tell you what your car should make before you commit to anything.

Call 0121 238 8663 Ask a question