Engine

Steyr Profi All years 6140 6.7L 140hp (103kW) 632Nm remap

Standard this engine makes 140hp and 632Nm. Our Stage 1 file takes it to 180hp and 825Nm.

+40horsepower
+193newton metres
1stage available

Where the power arrives

Both curves scaled from the manufacturer figures, on the Stage 1 file.

Power before and after
0499714619401,2001,6002,0002,400 RPM 0499714619401,4002,0002,600hp RPM
  • Standard 140hp
  • Remapped 180hp
Torque before and after
022344666889101,2001,6002,0002,400 RPM 022344666889101,4002,0002,600Nm RPM
  • Standard 632Nm
  • Remapped 825Nm

Stages for this engine

Stage 1 needs nothing fitted. Anything above assumes the supporting hardware is on the car already.

Every figure for the 6140 6.7L 140hp (103kW) 632Nm

FilePowerGainTorqueGainPrice
Standard140hpn/a632Nmn/an/a
Stage 1180hpup 40825Nmup 193ask us

Economy files show no new power figure because they are written for torque and drivability rather than peak output.

Remapping the 6140 6.7L 140hp (103kW) 632Nm

The Steyr Profi All years 6140 6.7L 140hp (103kW) 632Nm runs a factory calibration built to cope with poor fuel, skipped servicing and hot countries. We rewrite the fuelling, boost and timing for this engine on this car, then test it before you get it back. The original file is kept, so it can go back to standard whenever you want.

On the petrol side the difference shows in throttle response and in how hard it pulls through the top half of the rev range. It feels sharper off idle and keeps going where it used to flatten out.

Figures on this page are for a standard car in good health. We read the fault codes and check the basics first, and if something needs attention we will tell you before we write anything. Have a look at the other engines on the All years, the full Profi range, or everything we do for Steyr.

Book your Profi

We write and test every file at our Aston workshop, on our own rolling road. Ring us with your reg and we will tell you what your car should make before you commit to anything.