Petrol

Wiesmann GT / Roadster All years MF5 remap

Standard this engine makes 507hp and 520Nm. Our STAGE 1 file takes it to 537hp and 535Nm.

+30horsepower
+15newton metres
2stages available

Where the power arrives

Power and torque through the rev range, on the STAGE 1 file.

Power before and after
01452904355801,0002,2503,5254,7756,0257,300 RPM 01452904355801,0003,0255,0257,050hp RPM
  • Standard 507hp
  • Remapped 537hp
Torque before and after
01442894335781,0002,2503,5254,7756,0257,300 RPM 01442894335781,0003,0255,0257,050Nm RPM
  • Standard 520Nm
  • Remapped 535Nm

Stages for this engine

Stage 1 needs nothing fitted. Anything above assumes the supporting hardware is on the car already.

Every figure for the MF5

FilePowerGainTorqueGainPrice
Standard507hpn/a520Nmn/an/a
ECOn/an/a535Nmup 15£910
STAGE 1537hpup 30535Nmup 15£1,010

Economy files show no new power figure because they are written for torque and drivability rather than peak output.

Remapping the MF5

The Wiesmann GT / Roadster All years MF5 runs a factory calibration built to cope with poor fuel, skipped servicing and hot countries. We rewrite the fuelling, boost and timing for this engine on this car, then test it before you get it back. The original file is kept, so it can go back to standard whenever you want.

On the petrol side the difference shows in throttle response and in how hard it pulls through the top half of the rev range. It feels sharper off idle and keeps going where it used to flatten out.

Figures on this page are for a standard car in good health. We read the fault codes and check the basics first, and if something needs attention we will tell you before we write anything. Have a look at the other engines on the All years, the full GT / Roadster range, or everything we do for Wiesmann.

Book your GT / Roadster

We write and test every file at our Aston workshop, on our own rolling road. Ring us with your reg and we will tell you what your car should make before you commit to anything.