Engine

Renault Kerax All years 320 311hp (229kW) 1210Nm remap

Standard this engine makes 311hp and 1210Nm. Our Stage 1 file takes it to 361hp and 1390Nm.

+50horsepower
+180newton metres
1stage available

Where the power arrives

Both curves scaled from the manufacturer figures, on the Stage 1 file.

Power before and after
09719529239001,2001,6002,0002,400 RPM 09719529239001,4002,0002,600hp RPM
  • Standard 311hp
  • Remapped 361hp
Torque before and after
03757511126150101,2001,6002,0002,400 RPM 03757511126150101,4002,0002,600Nm RPM
  • Standard 1210Nm
  • Remapped 1390Nm

Stages for this engine

Stage 1 needs nothing fitted. Anything above assumes the supporting hardware is on the car already.

Every figure for the 320 311hp (229kW) 1210Nm

FilePowerGainTorqueGainPrice
Standard311hpn/a1210Nmn/an/a
Stage 1361hpup 501390Nmup 180ask us

Economy files show no new power figure because they are written for torque and drivability rather than peak output.

Remapping the 320 311hp (229kW) 1210Nm

The Renault Kerax All years 320 311hp (229kW) 1210Nm runs a factory calibration built to cope with poor fuel, skipped servicing and hot countries. We rewrite the fuelling, boost and timing for this engine on this car, then test it before you get it back. The original file is kept, so it can go back to standard whenever you want.

On the petrol side the difference shows in throttle response and in how hard it pulls through the top half of the rev range. It feels sharper off idle and keeps going where it used to flatten out.

Figures on this page are for a standard car in good health. We read the fault codes and check the basics first, and if something needs attention we will tell you before we write anything. Have a look at the other engines on the All years, the full Kerax range, or everything we do for Renault.

Book your Kerax

We write and test every file at our Aston workshop, on our own rolling road. Ring us with your reg and we will tell you what your car should make before you commit to anything.