Engine

Case Puma All years 230 227hp (167kW) 1089Nm remap

Standard this engine makes 227hp and 1089Nm. Our Stage 1 file takes it to 284hp and 1224Nm.

+57horsepower
+135newton metres
1stage available

Where the power arrives

Both curves scaled from the manufacturer figures, on the Stage 1 file.

Power before and after
07715323030701,5002,5003,5004,500 RPM 07715323030702,0003,5005,000hp RPM
  • Standard 227hp
  • Remapped 284hp
Torque before and after
0330661991132201,5002,5003,5004,500 RPM 0330661991132202,0003,5005,000Nm RPM
  • Standard 1089Nm
  • Remapped 1224Nm

Stages for this engine

Stage 1 needs nothing fitted. Anything above assumes the supporting hardware is on the car already.

Every figure for the 230 227hp (167kW) 1089Nm

FilePowerGainTorqueGainPrice
Standard227hpn/a1089Nmn/an/a
Stage 1284hpup 571224Nmup 135ask us

Economy files show no new power figure because they are written for torque and drivability rather than peak output.

Remapping the 230 227hp (167kW) 1089Nm

The Case Puma All years 230 227hp (167kW) 1089Nm runs a factory calibration built to cope with poor fuel, skipped servicing and hot countries. We rewrite the fuelling, boost and timing for this engine on this car, then test it before you get it back. The original file is kept, so it can go back to standard whenever you want.

On the petrol side the difference shows in throttle response and in how hard it pulls through the top half of the rev range. It feels sharper off idle and keeps going where it used to flatten out.

Figures on this page are for a standard car in good health. We read the fault codes and check the basics first, and if something needs attention we will tell you before we write anything. Have a look at the other engines on the All years, the full Puma range, or everything we do for Case.

Book your Puma

We write and test every file at our Aston workshop, on our own rolling road. Ring us with your reg and we will tell you what your car should make before you commit to anything.