Engine

Iveco EuroCargo All years E13/3.9L 130hp (96kW) 430Nm remap

Standard this engine makes 130hp and 430Nm. Our Stage 1 file takes it to 159hp and 640Nm.

+29horsepower

+210newton metres

1stage available

Where the power arrives

Both curves scaled from the manufacturer figures, on the Stage 1 file.

Power before and after

Standard 130hp
Remapped 159hp

Torque before and after

Standard 430Nm
Remapped 640Nm

Stages for this engine

Stage 1 needs nothing fitted. Anything above assumes the supporting hardware is on the car already.

Stage 1159hpup 29640Nmup 210

Every figure for the E13/3.9L 130hp (96kW) 430Nm

File	Power	Gain	Torque	Gain	Price
Standard	130hp	n/a	430Nm	n/a	n/a
Stage 1	159hp	up 29	640Nm	up 210	ask us

Economy files show no new power figure because they are written for torque and drivability rather than peak output.

Remapping the E13/3.9L 130hp (96kW) 430Nm

The Iveco EuroCargo All years E13/3.9L 130hp (96kW) 430Nm runs a factory calibration built to cope with poor fuel, skipped servicing and hot countries. We rewrite the fuelling, boost and timing for this engine on this car, then test it before you get it back. The original file is kept, so it can go back to standard whenever you want.

On the petrol side the difference shows in throttle response and in how hard it pulls through the top half of the rev range. It feels sharper off idle and keeps going where it used to flatten out.

Figures on this page are for a standard car in good health. We read the fault codes and check the basics first, and if something needs attention we will tell you before we write anything. Have a look at the other engines on the All years, the full EuroCargo range, or everything we do for Iveco.

Other engines on this EuroCargo

All years cars.

Book your EuroCargo

We write and test every file at our Aston workshop, on our own rolling road. Ring us with your reg and we will tell you what your car should make before you commit to anything.

Call 0121 238 8663 Ask a question