Engine

Iveco EuroCargo All years E24/5.9L 240hp (176kW) 810Nm remap

Standard this engine makes 240hp and 810Nm. Our Stage 1 file takes it to 279hp and 1090Nm.

+39horsepower
+280newton metres
1stage available

Where the power arrives

Both curves scaled from the manufacturer figures, on the Stage 1 file.

Power before and after
07515122630102,0004,0006,0008,000 RPM 07515122630103,0006,0009,000hp RPM
  • Standard 240hp
  • Remapped 279hp
Torque before and after
0294589883117702,0004,0006,0008,000 RPM 0294589883117703,0006,0009,000Nm RPM
  • Standard 810Nm
  • Remapped 1090Nm

Stages for this engine

Stage 1 needs nothing fitted. Anything above assumes the supporting hardware is on the car already.

Every figure for the E24/5.9L 240hp (176kW) 810Nm

FilePowerGainTorqueGainPrice
Standard240hpn/a810Nmn/an/a
Stage 1279hpup 391090Nmup 280ask us

Economy files show no new power figure because they are written for torque and drivability rather than peak output.

Remapping the E24/5.9L 240hp (176kW) 810Nm

The Iveco EuroCargo All years E24/5.9L 240hp (176kW) 810Nm runs a factory calibration built to cope with poor fuel, skipped servicing and hot countries. We rewrite the fuelling, boost and timing for this engine on this car, then test it before you get it back. The original file is kept, so it can go back to standard whenever you want.

On the petrol side the difference shows in throttle response and in how hard it pulls through the top half of the rev range. It feels sharper off idle and keeps going where it used to flatten out.

Figures on this page are for a standard car in good health. We read the fault codes and check the basics first, and if something needs attention we will tell you before we write anything. Have a look at the other engines on the All years, the full EuroCargo range, or everything we do for Iveco.

Book your EuroCargo

We write and test every file at our Aston workshop, on our own rolling road. Ring us with your reg and we will tell you what your car should make before you commit to anything.