Engine

Iveco EuroCargo All years E15/3.9L 150hp (110kW) 490Nm remap

Standard this engine makes 150hp and 490Nm. Our Stage 1 file takes it to 180hp and 700Nm.

+30horsepower
+210newton metres
1stage available

Where the power arrives

Both curves scaled from the manufacturer figures, on the Stage 1 file.

Power before and after
0499714619402,0004,0006,0008,000 RPM 0499714619403,0006,0009,000hp RPM
  • Standard 150hp
  • Remapped 180hp
Torque before and after
018937856775602,0004,0006,0008,000 RPM 018937856775603,0006,0009,000Nm RPM
  • Standard 490Nm
  • Remapped 700Nm

Stages for this engine

Stage 1 needs nothing fitted. Anything above assumes the supporting hardware is on the car already.

Every figure for the E15/3.9L 150hp (110kW) 490Nm

FilePowerGainTorqueGainPrice
Standard150hpn/a490Nmn/an/a
Stage 1180hpup 30700Nmup 210ask us

Economy files show no new power figure because they are written for torque and drivability rather than peak output.

Remapping the E15/3.9L 150hp (110kW) 490Nm

The Iveco EuroCargo All years E15/3.9L 150hp (110kW) 490Nm runs a factory calibration built to cope with poor fuel, skipped servicing and hot countries. We rewrite the fuelling, boost and timing for this engine on this car, then test it before you get it back. The original file is kept, so it can go back to standard whenever you want.

On the petrol side the difference shows in throttle response and in how hard it pulls through the top half of the rev range. It feels sharper off idle and keeps going where it used to flatten out.

Figures on this page are for a standard car in good health. We read the fault codes and check the basics first, and if something needs attention we will tell you before we write anything. Have a look at the other engines on the All years, the full EuroCargo range, or everything we do for Iveco.

Book your EuroCargo

We write and test every file at our Aston workshop, on our own rolling road. Ring us with your reg and we will tell you what your car should make before you commit to anything.