Engine

Iveco EuroCargo All years E14/3.9L 140hp (103kW) 460Nm remap

Standard this engine makes 140hp and 460Nm. Our Stage 1 file takes it to 158hp and 525Nm.

+18horsepower
+65newton metres
1stage available

Where the power arrives

Both curves scaled from the manufacturer figures, on the Stage 1 file.

Power before and after
0438512817102,0004,0006,0008,000 RPM 0438512817103,0006,0009,000hp RPM
  • Standard 140hp
  • Remapped 158hp
Torque before and after
014228442556702,0004,0006,0008,000 RPM 014228442556703,0006,0009,000Nm RPM
  • Standard 460Nm
  • Remapped 525Nm

Stages for this engine

Stage 1 needs nothing fitted. Anything above assumes the supporting hardware is on the car already.

Every figure for the E14/3.9L 140hp (103kW) 460Nm

FilePowerGainTorqueGainPrice
Standard140hpn/a460Nmn/an/a
Stage 1158hpup 18525Nmup 65ask us

Economy files show no new power figure because they are written for torque and drivability rather than peak output.

Remapping the E14/3.9L 140hp (103kW) 460Nm

The Iveco EuroCargo All years E14/3.9L 140hp (103kW) 460Nm runs a factory calibration built to cope with poor fuel, skipped servicing and hot countries. We rewrite the fuelling, boost and timing for this engine on this car, then test it before you get it back. The original file is kept, so it can go back to standard whenever you want.

On the petrol side the difference shows in throttle response and in how hard it pulls through the top half of the rev range. It feels sharper off idle and keeps going where it used to flatten out.

Figures on this page are for a standard car in good health. We read the fault codes and check the basics first, and if something needs attention we will tell you before we write anything. Have a look at the other engines on the All years, the full EuroCargo range, or everything we do for Iveco.

Book your EuroCargo

We write and test every file at our Aston workshop, on our own rolling road. Ring us with your reg and we will tell you what your car should make before you commit to anything.